+- MacResource (https://forums.macresource.com)
+-- Forum: My Category (https://forums.macresource.com/forumdisplay.php?fid=1)
+--- Forum: Tips and Deals (https://forums.macresource.com/forumdisplay.php?fid=3)
+--- Thread: zefal floor pump hose (/showthread.php?tid=260552)
zefal floor pump hose - Fritz - 10-09-2021
I have a very old but still good Zefal floor pump.
The flip lock chuck is extremely difficult to flip.
Does anyone know if the pump hose thread is standard?
I was thinking I'd get this flip lock chuck hose as a replacement, even though it's a little shorter than I'd like.
It's hose thread is .3"@32TPI
There's a 38" Planet replacement at beezees, too. But it's almost 2x$.
I'd think I'd get along with the 20" above (giggle).
beezee also has just the flip lock chuck (barbed), but it attaches to the old hose with a worm clamp. To close to the hand and I'm sure a bit less secure than a factory crimp.
Re: zefal floor pump hose - mattkime - 10-10-2021
I'd see if silca might be a good option for parts - https://silca.cc/collections/accessories-1/products/thread-on-schrader-chuck
https://silca.cc/collections/service-parts
Re: zefal floor pump hose - Fritz - 10-10-2021
nope.
Re: zefal floor pump hose - Buzz - 10-10-2021
? ? ?
==
Re: zefal floor pump hose - Fritz - 10-10-2021
older than that.
zefal hp husky. I'd guess more than 20 years. Still woks well.
Has a wood handle, not this modern plastic crap.
(giggle giggle giggle giggle, had to leave that)