04-21-2014, 11:39 AM
The hole in the bottom of the washer is there to let the pulley escape when it falls off.
Or possibly it could be for another reason.
I see a slot in the pin, so you've lost an e-clip or c-clip of some kind ... that secures the pulley.
I'd be inclined to go ahead and also order a new idler arm. If the pin is less than "whole" the new pulley may slip off prematurely (as opposed to when it "should" slip off?).
Or possibly it could be for another reason.
I see a slot in the pin, so you've lost an e-clip or c-clip of some kind ... that secures the pulley.
I'd be inclined to go ahead and also order a new idler arm. If the pin is less than "whole" the new pulley may slip off prematurely (as opposed to when it "should" slip off?).