MacResource › My Category › Tips and Deals v
cutting a 1 1/8" hole in plastic

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
cutting a 1 1/8" hole in plastic
apocketfulofwry Offline
Senior Member
****
Posts: 319
Threads: 31
Joined: May 2025
Reputation: 0
#12
10-11-2021, 06:40 PM
Pro tip: If you decide to go the hole saw route, after carefully drilling the initial hole, run the drill in reverse to prevent cracking especially if the plastic is brittle.
Find
Reply


Messages In This Thread
cutting a 1 1/8" hole in plastic - by Fritz - 10-11-2021, 03:21 PM
Re: cutting a 1 1/8" hole in plastic - by cbelt3 - 10-11-2021, 03:26 PM
Re: cutting a 1 1/8" hole in plastic - by Fritz - 10-11-2021, 03:32 PM
Re: cutting a 1 1/8" hole in plastic - by cbelt3 - 10-11-2021, 03:35 PM
Re: cutting a 1 1/8" hole in plastic - by Fritz - 10-11-2021, 03:39 PM
Re: cutting a 1 1/8" hole in plastic - by Fritz - 10-11-2021, 03:45 PM
Re: cutting a 1 1/8" hole in plastic - by Gareth - 10-11-2021, 04:29 PM
Re: cutting a 1 1/8" hole in plastic - by John B. - 10-11-2021, 05:17 PM
Re: cutting a 1 1/8" hole in plastic - by apocketfulofwry - 10-11-2021, 06:40 PM
Re: cutting a 1 1/8" hole in plastic - by Fritz - 10-11-2021, 06:42 PM
Re: cutting a 1 1/8" hole in plastic - by Bernie - 10-11-2021, 07:41 PM
Re: cutting a 1 1/8" hole in plastic - by Fritz - 10-11-2021, 08:23 PM
Re: cutting a 1 1/8" hole in plastic - by Ken Sp. - 10-11-2021, 10:54 PM
Re: cutting a 1 1/8" hole in plastic - by Bernie - 10-11-2021, 11:11 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)