07-28-2007, 06:59 PM
[quote GGD]I think I've seen this before, is it an MDD G4 with two ATA buses? I think Target Disk Mode will only show one drive, the Master position on the rear ATA bus (where Apple put the hard drive from the factory), and if there is no drive there, it will shut down.
That sounds like it. It is indeed a MDD G4 with 2 ATA busses.
And the reason for not using the G5? Its just easier. Everything is connected to the G5. All my apps are running etc. The G4 is empty and running solo. I guess I just need to set the jumper to Master than. I'm pretty sure its CS now.
That sounds like it. It is indeed a MDD G4 with 2 ATA busses.
And the reason for not using the G5? Its just easier. Everything is connected to the G5. All my apps are running etc. The G4 is empty and running solo. I guess I just need to set the jumper to Master than. I'm pretty sure its CS now.