MacResource › My Category › Tips and Deals v
advice on screw bits

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
advice on screw bits
OWC Jamie Offline
Unregistered
Posts: 50,838
Threads: 670
Joined: Mar 2024
#13
11-30-2007, 03:55 PM
The right screw
the right bit

drill driver should be on low speed and clutch on minimum (just like you would if using an air tool)
pre-drill holes where required.
Find
Reply


Messages In This Thread
advice on screw bits - by bazookaman - 11-30-2007, 01:03 PM
Re: advice on screw bits - by mikebw - 11-30-2007, 01:27 PM
Re: advice on screw bits - by Cary - 11-30-2007, 01:40 PM
Re: advice on screw bits - by yeoman - 11-30-2007, 01:43 PM
Re: advice on screw bits - by bazookaman - 11-30-2007, 01:55 PM
Re: advice on screw bits - by olnacl - 11-30-2007, 02:39 PM
Re: advice on screw bits - by BigGuynRusty - 11-30-2007, 02:42 PM
Re: advice on screw bits - by cbelt3 - 11-30-2007, 03:07 PM
Re: advice on screw bits - by Cary - 11-30-2007, 03:12 PM
Re: advice on screw bits - by yeoman - 11-30-2007, 03:17 PM
Re: advice on screw bits - by mattkime - 11-30-2007, 03:19 PM
Re: advice on screw bits - by bazookaman - 11-30-2007, 03:40 PM
Re: advice on screw bits - by billb - 11-30-2007, 03:55 PM
Re: advice on screw bits - by tenders - 11-30-2007, 04:08 PM
Re: advice on screw bits - by BigGuynRusty - 11-30-2007, 04:19 PM
Re: advice on screw bits - by bazookaman - 11-30-2007, 04:39 PM
Re: advice on screw bits - by billb - 11-30-2007, 05:16 PM
Re: advice on screw bits - by tenders - 11-30-2007, 06:27 PM
Re: advice on screw bits - by Cary - 11-30-2007, 07:37 PM
Re: advice on screw bits - by BigGuynRusty - 11-30-2007, 08:18 PM
Re: advice on screw bits - by billb - 11-30-2007, 08:58 PM
Re: advice on screw bits - by Mike Johnson - 11-30-2007, 09:17 PM
Re: advice on screw bits - by bazookaman - 11-30-2007, 09:29 PM
Re: advice on screw bits - by Grateful11 - 12-01-2007, 04:11 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)