Posts: 5,614
Threads: 2,835
Joined: May 2025
Reputation:
0
On back of this 4 ft by 2.5 ft, framed mirror, it says do not use Picture Wire to hang. USE D HOOKS.
It seems to weigh about 2 16 lb bowling balls worth. Havent got on a scale with it yet, but it is heavy and cumbersome for one person to hold up.
So I bought some 50 lb D Hooks at Home Depot. Not I would need to fasten them to the Frame of the mirror, and then hang the mirror from the two D Hooks on something I attach to the wall. I have read and seen a lot of items. Any recommendations?
Thanks.
Oh, this is an original Lath and Plaster type of wall. No Drywall. And I suppose I could locate the studs with a stud finder, if it fell in just the right spot
Posts: 21,885
Threads: 1,109
Joined: Mar 2024
Reputation:
0
I have seen mirrors held up with construction adhesive- which works really well but can ruin the mirror if you ever want to take it off the wall again.
Posts: 3,935
Threads: 227
Joined: May 2025
Reputation:
0
Short of hitting a stud (you'd probably only hit one anyway), plastic or metal expanding wall anchors should be just fine. Make sure they're rated for a high enough sheer weight. If you want something stronger for your own peace of mind, a toggle bolt isn't going anywhere.
Edit: Scratch the toggle bolt. Wouldn't work with D rings.
Most home centers have a nice display in the anchor area that explains how to use each one and proper applications for the different types. Use this and whatever the package says, and you'll be fine.
Posts: 4,821
Threads: 374
Joined: Jul 2020
I'd still aim for the studs to secure it. It's glass and I wouldn't want to take a chance on the plaster wall failing.
Posts: 13,305
Threads: 2,485
Joined: May 2025
If it's 4' wide, you should have no problem hitting two studs.
Posts: 9,822
Threads: 277
Joined: Aug 2024
Reputation:
0
Id suggest you find a couple of studs with stud finder. If mirror center lands on one, you are set. If not, set a brace between the studs that will allow you to set the mirror in your desired location.
Joe
Posts: 3,935
Threads: 227
Joined: May 2025
Reputation:
0
Obviously, I haven't seen the mirror in question, but in many cases, I wouldn't trust the top of the frame to hold the weight. Plus, the D hooks you bought are probably attached to metal straps of some length.
The mirror I picture in my head probably doesn't have a thick enough frame to accommodate that length at the top anyway. Attach the D rings to the sides (vertical parts of the frame). Figure out where you want to hang it. If there is a stud nearby one side, go for it. Use a drywall/plaster anchor for the other side, rated for enough weight for that half of the mirror. I usually go overkill on these, only for my own peace of mind. It'll probably only cost a few cents more to go for one size higher than "adequate".
Regarding the brass hooks above, if you find something like that rated for enough weight, fine. Personally, I don't like the looks of them for a heavy load. Again, this is just my own fear speaking here.
