Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Paver stone cement. An inch or two too large, possible to chip a bit off?
#10
"For a single cut I would just get a brick chisel. Like Rudie said, just mark your cut line with a straight line. The idea is to create a stress fracture so the paver splits naturally along the line. I would first score it at each end of the cut and then work from the ends towards the middle. Remember that you are just creating a scored line with the chisel and not cutting through. It should fracture and split before you get too deep."

"You might also check to see if local big box rents a paver/brick splitter. It is like a giant tile cutter. It scores the line and then snaps it. They may cut one at the store for you for free."

Phil has done this before me thinks *(:>* And he describes the process better ...

Goodluck MacDoxy ~!~ You can do it . Just take your time.

Rudie:priate:
Reply


Messages In This Thread
Re: Paver stone cement. An inch or two too large, possible to chip a bit off? - by haikuman - 10-24-2011, 05:54 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)